High voltage relays are GLX-RELAY and uses 24V DC. You have to ether replace the board with a Prologic board or go with another controller.
#Aqua logic pool control panel upgrade#
Unfortunately, it is not possible to upgrade the board firmware. You need software version 2.65 or higher to support a VS pump.
Replacing U2 and X2 is not an easy soldering job if you are not used to surface mount parts, don't try it.Īfter replacing parts you need to wait about 24 hours for the real time clock to start working and then adjusting it to current time. Some people replaced just the C3 capacitor, others repalced C3 and X2, and others replaced U2, X2 and C3. X2-is a 32.768 kHz Crystal Epson MC-306 / 6 pF (SER4099CT-ND at Digikey) and costs $.046.U2-Real Time Clock is Dallas / Maxim RTC is $3.50 at Digikey (DS1302Z+CT-ND).U1-Microprocessor is PIC18F2620 (28 pin version).After replacement you run for 1 hr it will charge the battery. You can buy on Ebay for about $3 and 5 mins to replace it. On the board it has a capacitor on the left top corner, it's like a double battery in wrap. You can replace the board or try repairing the board. Ī thread on this board repair can be found at Hayward ECommand not keeping time: updated DIY repair guide. If you select the cell size to t-3, t-5 or t-9 instead of the correct t-15 then the salt readout from the controller will be high salt. Ĭheck under the diagnostics menu for the correct cell size. If the volts are more than 32 at any point, the circuit board is probably damaged. If it says high salt, the amps were above 8.0. This can be caused by high salt but also by high water temperatures. The “Chlorinator Off High Salt” warning comes on when the current exceeds 8 amps regardless of the salt level. Don't add salt until you verify the water salt level with a Taylor K-1766 Test Kit or Salt test strips. Low salt messages are often the first indication of a failing cell.
#Aqua logic pool control panel serial#
0 kommentar(er)
